FE Electrical exam · Section 7 · Linear Systems
Resonance in RLC circuits: frequency, Q and bandwidth, worked example
A circuit with an inductor and a capacitor has one frequency where their reactances are equal and cancel. At that resonant frequency a series RLC circuit looks like a plain resistor, its current peaks, and the voltages across L and C can be many times the source voltage.
- Linear Systems: 5–8 of 110 exam questions
- 1 worked example · 2 practice problems
How it works
Inductive reactance rises with frequency and capacitive reactance falls. Resonance is the frequency where the two curves cross.
The quality factor Q says how sharp the peak is. A high Q means only a narrow band of frequencies gets through. Bandwidth is the distance between the two half-power frequencies.
For a series circuit, a small resistance means a high Q. For a parallel circuit it is the other way round: a large resistance means a high Q.
The formulas you need
- Resonant frequency
- Series RLC
- Parallel RLC
Worked example
The problem
A series circuit has R = 10 Ω, L = 25 mH and C = 100 nF, driven by a 5 V rms source. Find the resonant frequency, the quality factor, the bandwidth, and the current and the capacitor voltage at resonance.
- R
- 10 Ω
- L
- 25 mH
- C
- 100 nF
- Source
- 5 V rms
Step 1: Resonant frequency
Convert to henries and farads first.
Step 2: Quality factor
Step 3: Bandwidth
Step 4: Current at resonance
The reactances cancel, so only R limits the current.
Step 5: Capacitor voltage at resonance
It is Q times the source voltage.
Answer
20,000 rad/s (3,183 Hz), Q = 50 and a bandwidth of 400 rad/s. At resonance the current is 0.5 A and the capacitor sees 250 V, fifty times the 5 V source.
Common mistakes
- Mixing rad/s and hertz. gives rad/s. Divide by for hertz.
- Leaving L in millihenries or C in nanofarads.
- Using the series formula for Q on a parallel circuit. The two are upside down relative to each other.
Practice problems
Work each one on paper first, then open the answer.
1. Find the resonant frequency in hertz for L = 10 mH and C = 1 µF.
Show the answerHide the answer
1,592 Hz
rad/s, and Hz.
2. A parallel RLC circuit has R = 500 Ω, L = 1 mH and C = 10 µF. Find Q and the bandwidth.
Show the answerHide the answer
Q = 50 and 200 rad/s
rad/s. . rad/s.
FE Electrical course · Lesson 7.2 · 6 min
Watch this topic as a video lesson
Lesson 7.2, Resonance, is part of the FE Electrical Exam Pass. The first section of the course is free with a VoltIQ account, so you can try the lessons before you pay anything.
- A 6-minute animated video that walks through the topic step by step
- Five practice questions with worked solutions
Keep going
Not sure where you stand? The free FE Electrical diagnostic has 17 questions, scored by topic, with an explanation for each.
Take the diagnosticWritten by VoltIQ Academy for exam preparation. The example and practice problems are our own. VoltIQ Academy is not affiliated with or endorsed by NCEES. This page is study material, not design guidance for a real installation.