FE Electrical exam · Section 6 · Circuit Analysis
Thévenin and Norton equivalents: worked example and practice problems
Thévenin's theorem replaces everything a load is connected to with one voltage source and one series resistor. Norton's theorem does the same with a current source and a parallel resistor. Both describe the same circuit, and either one turns a long problem into a voltage divider.
- Circuit Analysis: 11–17 of 110 exam questions
- 1 worked example · 2 practice problems
How it works
The Thévenin voltage is what you would measure at the terminals with the load removed: the open-circuit voltage.
The Thévenin resistance is what you see looking back into the terminals with every independent source switched off. A voltage source that is switched off is a short circuit. A current source that is switched off is an open circuit.
The Norton current is what flows through a wire placed across the terminals: the short-circuit current. The three quantities are tied together, so any two of them give the third.
A load receives the most power when its resistance equals the Thévenin resistance.
The formulas you need
- Thévenin voltage
- Norton current
- Resistance from two measurements
- Maximum power, when the load equals the Thévenin resistance
Worked example
The problem
A 24 V source is in series with a 6 Ω resistor. A 12 Ω resistor connects from the far end of the 6 Ω resistor back to the source's negative terminal. A 4 Ω resistor runs from that same node to output terminal a. Terminal b is the negative terminal. Find the Thévenin and Norton equivalents at a-b, the maximum power available to a load, and the power in a 24 Ω load.
- Source
- 24 V
- Series resistor
- 6 Ω
- Shunt resistor
- 12 Ω
- Output resistor
- 4 Ω to terminal a
Step 1: Open-circuit voltage
With nothing connected, no current flows in the 4 Ω resistor, so the terminal voltage is the voltage across the 12 Ω resistor.
Step 2: Thévenin resistance
Replace the source with a short. The 6 Ω and 12 Ω resistors are then in parallel, in series with the 4 Ω.
Step 3: Norton equivalent
A 2 A source in parallel with 8 Ω.
Step 4: Maximum power
This happens with an 8 Ω load.
Step 5: Power in a 24 Ω load
Answer
Thévenin: 16 V in series with 8 Ω. Norton: 2 A in parallel with 8 Ω. The most a load can receive is 8 W, with an 8 Ω load. A 24 Ω load receives 6 W.
Common mistakes
- Leaving the load connected while finding the Thévenin voltage or resistance.
- Opening a voltage source instead of shorting it, or shorting a current source instead of opening it.
- Dropping the 4 Ω resistor from the resistance because it carried no current in the open-circuit step. It still counts.
Practice problems
Work each one on paper first, then open the answer.
1. A network has V and . Give its Norton equivalent and the maximum power it can deliver to a load.
Show the answerHide the answer
2 A in parallel with 5 Ω, and 5 W
A. W.
2. A source measures 12 V with nothing connected and delivers 3 A into a short circuit. What is its Thévenin resistance?
Show the answerHide the answer
4 Ω
.
FE Electrical course · Lesson 6.3 · 5 min
Watch this topic as a video lesson
Lesson 6.3, Thévenin, Norton and maximum power, is part of the FE Electrical Exam Pass. The first section of the course is free with a VoltIQ account, so you can try the lessons before you pay anything.
- A 5-minute animated video that walks through the topic step by step
- Five practice questions with worked solutions
Keep going
Not sure where you stand? The free FE Electrical diagnostic has 17 questions, scored by topic, with an explanation for each.
Take the diagnosticWritten by VoltIQ Academy for exam preparation. The example and practice problems are our own. VoltIQ Academy is not affiliated with or endorsed by NCEES. This page is study material, not design guidance for a real installation.